ToughSignal Industrial Gigabit PoE++ Splitter 5–36V

Introducing the ToughSignal Industrial Gigabit PoE++ Splitter 5–36V

The ToughSignal Industrial Gigabit PoE++ Splitter 5–36V separates power and Gigabit Ethernet data from a single PoE connection, providing a programmable DC terminal-block with 5-36V DC output for compatible non-PoE equipment. Designed for rugged mobile and fixed installations, it supports IEEE 802.3af/at/bt PoE++ and delivers 45–75W nominal power with up to 90W max momentary burst output when supplied by a properly capable PoE++ source.

This splitter is particularly suited for Peplink Antenna MAX S installations, where it can be used to deliver power for a Starlink Mini and Peplink router over a single Ethernet cable when paired with the correct 802.3bt PoE++ injector or switch. This version also adds a front-panel digital LED readout and output adjustment control for easier monitoring and setup.

This splitter incorporates a front-panel digital LED readout for at-a-glance electrical monitoring of wattage, voltage and tempature along with an integrated output adjustment control. 

An IP40 rugged enclosure, redundant power design, DIN-rail mounting support, and included wall-mount hardware make the splitter suitable for professional installations where equipment may be exposed to wide temperature swings, vibration, or limited installation space.

High-Power variable 5-36VDC Output with Gigabit Data

One RJ45 port accepts incoming PoE power and Ethernet data while a second RJ45 port provides Gigabit Ethernet data passthrough (no PoE). Power is separated to the direct-wire terminal block for DC equipment, allowing compatible devices to receive DC power without requiring a local AC power source at the installation point. The upgraded terminal block now features 4 pins with 2 possitive and 2 negative terminals for easier installation of multiple accessories. 

The industrial enclosure supports DIN-rail or wall mounting and is designed to operate from -40°C to 80°C (-40°F to 176°F). Ethernet runs can extend up to 100 meters when installed with high-quality shielded Ethernet cabling, making the splitter useful for vehicle, rooftop, enclosure, and remote networking applications.

Important Power Compatibility Notice: Not all PoE++ injectors and switches can provide sufficient power from a single Ethernet port. While this splitter may operate with other PoE sources, the full 45–75W nominal output and 90W max burst capability requires a properly wired 802.3bt PoE++ injector or switch capable of supplying up to 90W on one port. The PoE source must also have a suitable 12-48V DC input source and adequate wiring for optimal performance. For Starlink Mini applications, we recommend pairing this splitter with the compatible PoE Injector listed as an accessory on this page or with our ToughSignal switches.

Peplink Devices: Most Peplink devices have a maximum DC input voltage of 30V DC, take special care not to exceed this voltage when installing this product with Peplink hardware. Failure to do so is not covered under warranty.

Core Functions

• High-Power PoE++ Splitting: Separates Gigabit Ethernet data and DC power from an IEEE 802.3af/at/bt PoE input with 45–75W nominal and 90W max burst capability.
• 5-36VDC Direct-Wire Output: Provides DC power through a 4-pin terminal block while maintaining Gigabit Ethernet data passthrough through a separate RJ45 port.
• Integrated Monitoring & Adjustment: Front-panel digital LED monitoring and output adjustment control simplify installation, verification, and system setup.

Best For

• Peplink Antenna MAX S installations
• Starlink Mini and Peplink router power deployments
• Mobile and vehicle network systems
• Remote and rooftop networking installations
• Industrial DIN-rail or wall-mounted applications

ToughSignal_TS-POE-SPLT-90W-Data Sheet.pdf